HP 5400R zl2 Quick Setup Guide and Safety/Regulatory Information

3
Software version
For the latest software version, go to: www.hp.com/networking/support
Installation notes
Transceiver operation notes
Revision “B” or later SFP transceivers only. This product requires revision “B” or later mini-GBICs or SFP transceivers
(product number ends with the letter “B” or later, for example J4858B or J4859C). These switches do not support revision “A”
mini-GBIC or SFP transceivers. This applies only to SFP transceivers and not SFP+ transceivers.
Use only genuine HP transceivers: Non-HP transceivers are not supported. Use of genuine products ensures that your
n
etwork maintains optimal performance and reliability. Should you require additional HP transceivers, please contact an HP
sales representative or an authorized reseller. For a complete list of supported transceivers, visit the HP networking Web site
at
www.hp.com/networking/support. Locate FAQs, and under Mini-GBICs and Transceivers, select one of the following:
■ HP 10-GbE Transceivers and Cables
■ HP Mini-GBICs and SFPs
Click on the first question in the “General
product information” category.
1. Remove the slot cover plate.
2. Align the power supply in the switch slot and insert
it un
til the external wall of the power supply is flush
with the switch chassis.
3. Tighten the retaining screws to secure the power
supp
ly to the switch.
1 Grounding Lug
Mounting Holes
2 Power Supply Slots