Installation Guide (J8732A) 2005-09

ProCurve Switch fl Redundant Power Supply
ProCurve Switch fl Redundant Power
Supply
For the ProCurve Switch 8100fl Series
The ProCurve Switch fl Redundant Power Supply (J8732A) is an AC power
supply that you can add to a ProCurve Switch 8108fl or Switch 8116fl to
provide additional redundancy and to ensure switch reliability. The power
supply operates between 100–240 VAC. Each component on the switch
(management module, interface module, and so on) regulates its own power
needs.
A ProCurve Switch 8100fl supports up to three AC power supplies. For the
Switch 8108fl, one power supply is required to operate a fully-populated
chassis—an optional second power supply provides full redundancy. For the
Switch 8116fl, two power supplies are required to operate a fully-populated
chassis—an optional third power supply provides redundancy.
The Switch 8108fl is shipped with a single AC power supply plus two blank
covers (P/N: 1530-2431); the Switch 8116fl is shipped with two AC power
supplies and one blank cover. Extra slots in the front of each chassis allow for
the use of additional power supplies: (one mandatory and one optional) in the
Switch 8108fl and (two mandatory and one optional) in the Switch 8116fl.
Blank Covers
Installed
Power Supply
Not e For any power supply slot into which a power supply is not installed, a blank
cover is required for safe operation, and to ensure proper switch cooling.
1