HP StorageWorks Fabric OS 5.0.5f Release Notes (AA-RW1WH-TE, December 2007)

• tstimezone [hourOffset [, m inuteOffset]]

hourOffset (optional) — Specify the number of hours relative to GMT; must be an integer. Valid

values are -12 through 12.

minuteOffset (optional) — Specify the number of minutes relative to the hourOffset value; must be

an integer. Valid values are -30, 0, or 30. The hourOffset can be speciﬁed without a minuteOffset,

whichthendefaultstozero.

• tstimezone — <timezonename>

zonename — The name of the zoneinfo time zone; will vary as additional time zones are added.

For example, to display the current time zone setup, then change them to GMT-3:30:

switch:admin> tsTimeZone

Time Zone Hour Offset: 0

Time Zone Mi

nute Offset: 0

switch:admin> tsTimeZone -3, -30

Updating Ti

me Zone configuration...done.

System Tim

e Zone change will take effect at next reboot.

switch:admin> tsTimeZone

Time Zone H

our Offset: -3

Time Zone M

inute Offset: -30

Security-related enhancement

A new role-based access control role, switch administrator, allows an administrator to control a switch

but not modif y any fabric-wide conﬁguration, that is, security, zoning, or user con ﬁguration (see the

userConfig command).

Merging zone

Before linki

ng two switches together, it is important to know the zone database limit of adjacent switches.

For details

, refer to the section “Merging Zones,” in the F abric OS Administrator’s Guide.

Important notes

The following sections list important notes.

Obtaining a PKI Certiﬁcate for Secure Fabric OS

For information on activating Se cure Fabric OS go to the following HP website:

ttp://www.hp.com/storage/go/secureos

Also, y ou may refer to the Secure Fabric OS Administrator’s Guide, Chapter 2, “Preparing the Fabric

for Secure Fabric OS,” for speciﬁc procedures.

Non-default operands

The use of non-default operands for diagnostic commands is recommended for advanced users and

ﬁeld suppor t only.

Need to t

urn traps on manually

The SilkWorm and FA traps in pre-Fabric OS 4.4.0 code were turned on and off as a group; and

it wasn’t possible to set individual SilkWorm or FA traps. In 4.4.0 the ability to turn traps on and off

HP StorageWorks Fabric OS 5.0.5f release notes