HP StorageWorks Fabric OS 5.3.x administrator guide (5697-0244, November 2009)

272 Administering FICON fabrics
7. Respond to the remaining prompts (or press Ctrl-d to accept the other settings and exit).
8. Enter the switchEnable command to re-enable the switch.
Displaying information
You can display link incidents, registered listeners, node identification data, and FRU failures, as described
in the following procedures.
Link incidents
The registered link incident record (RLIR) ELS contains the link incident information sent to a listener N_Port.
To display link incidents, connect to the switch, log in as user, and enter one of the following commands:
• For the local switch: ficonshow rlir
• For all switches defined in the fabric: ficonshow rlir fabric
Registered listeners
To display registered listeners for link incidents, connect to the switch, log in as user, and enter one of the
following commands:
• For the local switch: ficonshow lirr
• For all switches defined in the fabric: ficonshow lirr fabric
Node identification data
To display node-identification data, connect to the switch, log in as user, and enter any of the
following commands:
• For the local switch: ficonshow switchrnid
• For all switches defined in the fabric: ficonshow switchrnid fabric
• For all devices registered with the local switch: ficonshow rnid
• For all devices registered with all switches defined in the fabric: ficonshow rnid fabric
switch:admin> configure
Configure...
Fabric parameters (yes, y, no, n): [no] yes
Domain: (1..239) [3] 5
R_A_TOV: (4000..120000) [10000]
E_D_TOV: (1000..5000) [2000]
Data field size: (256..2112) [2112]
Sequence Level Switching: (0..1) [0]
Disable Device Probing: (0..1) [0]
Suppress Class F Traffic: (0..1) [0]
VC Encoded Address Mode: (0..1) [0]
Per-frame Route Priority: (0..1) [0]
Long Distance Fabric: (0..1) [0]
BB credit: (1..16) [16]
Insistent Domain ID Mode (yes, y, no, n): [no] y
Virtual Channel parameters (yes, y, no, n): [no]
Switch Operating Mode (yes, y, no, n): [no]
Zoning Operation parameters (yes, y, no, n): [no]
RSCN Transmission Mode (yes, y, no, n): [no]
Arbitrated Loop parameters (yes, y, no, n): [no]
System services (yes, y, no, n): [no]
Portlog events enable (yes, y, no, n): [no]
Committing configuration...done.
switch:admin>