HP StorageWorks Fabric OS 5.3.x administrator guide (5697-0244, November 2009)

Fabric OS 5.3.0 administrator guide 93
Accessing switches and fabrics
If you are using the FC-FC Routing Service, be aware that you cannot execute the secModeEnable
command on backbone fabrics (you cannot run this command in secure mode when a backbone fabric is
connected to edge fabrics). Refer to ”Using the FC-FC routing service” on page 227 for details about the
FC-FC Routing Service and it relationship with Secure Fabric OS.
Table 20 lists the defaults for accessing hosts, devices, switches, and zones.
Port configuration
Table 20 lists the ports used. This table provides the information to make it clearer when configuring the
switch, taking into consideration firewalls and other devices that may sit between switches in the fabric or
between the managers and the switch.
Table 20 Access defaults
Hosts Any host can access the fabric by SNMP
Any host can telnet to any switch in the fabric
Any host can establish an HTTP connection to any switch in the fabric
Any host can establish an API connection to any switch in the fabric
Devices All device ports can access SES
All devices can access the management server
Any device can connect to any FC port in the fabric
Switch access Any switch can join the fabric
All switches in the fabric can be accessed through serial port
Zoning Node WWNs can be used for WWN-based zoning
Table 21 Port information
Port Type Common use Comment
22 TCP SSH
23 TCP Telnet
Use the configure command to
disable the telnet service.
37 TCP NTP
80 TCP HTTP
Use the configure command to
disable the port.
111 T C P s u n r p c
This port is used by Platform API.
Use the configure command to
enable or disable daemons.
161 U D P SN M P
Disable the SNMP service on the
remote host if you do not use it, or
filter incoming UDP packets going to
this port.
443 TCP HTTP
Supported service (Web Tools).
Disable this port using the config-
ure command.