Manualshelf

Brocade Network Advisor Migration Guide - Supporting Network Advisor 11.1.X (53-1002321-01, May 2011)

ManualsBrandsHP ManualsSoftwareHP B-series Data Center Fabric Manager Enterprise Software
71727374757677787980
74 of 82 Brocade Network Advisor Migration Guide
53-1002321-01
Unsupported server migration
Unsupported server migration
If the server that you installed Network Advisor on does not meet the system requirements (refer to “System
requirements” on page 13), use the following procedure to migrate from your current server to a new server.
Migrating to a new server
1. Perform a partial uninstall of Network Advisor (refer to “Uninstallation” on page 81) on the current server.
NOTE
If the Source version is fully installed on the remote server, stop services from the Server Management Console
dialog box.
2. Install Network Advisor (refer to “Installing the application” on page 24) on the new server.
3. Click Next on the Welcome screen.
4. Select Yes, from Network Advisor installed in this machine or on network and click Browse to browse to the
installation directory where you partially uninstalled the application.
5. Click Next on the Copy Data and Settings screen.
6. Click Start on the Data Migration screen.
Data migration may take several minutes. When data migration is complete, the previous version is partially
uninstalled.
7. Cl ick Next on the Data Migration screen.
8. Select the source edit type on the Installation Type screen and click Next.
9. If you are migrating to Licensed Version software, enter the license key (on the Key Certificate) on the Server
License screen or browse to the license file (.xml) and click Next.
The License Key field is not case-sensitive.
10. (SAN with SMI Agent) Select Internal FTP Server or External FTP Server on the FTP Server screen and click Next.
The default selection reflects the previous Professional Plus edition configuration.
If port 21 is busy, a message displays. Click OK to close the message and continue. Once the Management
application is configured make sure port 21 is free and restart the Server to start the FTP service.
NOTE
If you select to use an FTP Server which is not configured on the same machine as Network Advisor, the
Firmware Repository feature will not be available.