Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

92 Brocade Network Advisor SAN User Manual
53-1002167-01
SAN Display
4
Resetting your display
You can reset your system to display the default display settings. Note that returning to current
settings after a reset may require configuring each global fabric or group setting individually. The
following table (Table 13) details the settings that change with reset and the associated default
state.
To reset the Management application to the default display and view settings, complete the
following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select SAN Display in the Category list.
3. Click Reset Display.
4. Click Yes on the reset confirmation message.
The display and view settings are immediately reset to the default display settings (as detailed
in the Default display Settings table (Table 13)).
5. Click Apply or OK to save your work.
TABLE 13 Default Display Settings
Settings Default State
Show port Disabled.
Show connected end device Set to Hide All.
Map Layout Set to default for Groups.
Line Types Set to default for Groups.
Port Display Set to Attached Ports only.
Map Flyovers Set to include the following properties:
• Product Display—Name, Device Type, WWN, IP Address, and Domain ID.
• Connection Display—Name (port), Address, Node WWN, Port WWN, and Port #.
Product List Set to only display basic property list.
Table Column Order Set to default for open system.