Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

102 Brocade Network Advisor SAN User Manual
53-1002167-01
SAN Names
4
2. Click Fix Duplicates.
The Duplicated Names dialog box displays.
3. Select one of the following options.
• If you select Append Incremental numbers for all repetitive names, the names are edited
automatically using incremental numbering.
• If you select I will fix them myself, edit the name in the Name field.
4. Click OK on the Duplicated Names dialog box.
5. Click OK to close the Configure Names dialog box.
6. Click OK on the confirmation message.
Viewing names
To view names associated with devices by name, complete the following steps.
1. Select Configure > Names.
The Configure Names dialog box displays.
2. Select All Names from the Display list.
Only devices with a name display. The table displays the Name, WWN, Operational Status,
Type, and a Description of the device.
3. Click OK to close the Configure Names dialog box.
Adding a name to an existing device
To add a name to an existing device, complete the following steps.
1. Select Configure > Names.
The Configure Names dialog box displays.
2. Select how you want to display devices from the Display list.
You can display devices by All Names, All WWNs, Fabric Assigned WWNs, Only Fabrics, Only
Products, Only Ports, or Switch and N Ports.
All discovered devices display.
3. Select the device to which you want to assign a name in the Display table.
4. Double-click in the Name column for the selected device or port and enter a name for the
device or port.
If you set names to be unique on the Options dialog box and the name you entered already
exists, the entry is not accepted. To search for the device already using the name, refer to
“Searching for a device by name” on page 105 or “Searching for a device by WWN” on
page 106 in the Configure Names dialog box or “Searching for a device” on page 193 in the
connectivity map.
NOTE
If you segment a fabric, the Fabric’s name follows the assigned principal switch.