Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 115
53-1002167-01
Software Configuration
4
Client/Server IP
You can configure connections between the client or switches and the Management application
server.
Configuring the server IP address
NOTE
The server binds using IPv6 address by default if your Operating System is IPv6-enabled (dual mode
or IPv6 only). The server binds using IPv4 address by default if your Operating System is
IPv4-enabled. Servers running in dual mode allow the client to communicate from both IPv6 and
IPv4 addresses.
To configure the IP address used by the server for client-server communications, complete the
following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Client/Server IP in the Category list to set the IP address.
FIGURE 48 Options dialog box (Client/Server IP option)