Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

166 Brocade Network Advisor SAN User Manual
53-1002167-01
Editing a call home center
6
7. Enter the path to the ConnectEMC application in the ConnectEMC field or browse to the
ConnectEMC application location.
8. Enter the phone number or extension of the local server in the Local Server - Modem # field.
9. Enter the identification number of the local server in the Local Server - Cabinet Serial # field.
10. Enter the site name for the local server in the Local Server - Site Name field.
11. Click Send Test to test the Connect EMC application.
The selected call home center must be enabled to test the Connect EMC application.
A faked event is generated and sent to the selected call home center. You must contact the call
home center to verify that the event was received and in the correct format.
12. Click OK.
The Call Home dialog box displays with the call home center you edited highlighted in the Call
Home Centers table.
13. Click OK to close the Call Home dialog box.
Editing the HP LAN call home center
To edit an HP LAN call home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
The Call Home dialog box displays.
2. Select the HP LAN call home center you want to edit in the Call Home Centers table.
3. Click Edit Centers (beneath the Call Home Centers table).
The Configure Call Home Center dialog box displays (Figure 61).
FIGURE 61 Configure Call Home Center dialog box (HP LAN option)
4. Make sure the HP LAN call home center type displays in the Call Home Centers list.
5. Select Enable to enable this call home center.
6. Enter the IP address of the call home center in the Service Gateway field.