Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 273
53-1002167-01
Ports
10
Refreshing the port connectivity view
To obtain configuration changes that occurred since the Port Connectivity View dialog box opened,
click Refresh.
Enabling a port
To enable a port from the port connectivity view, right-click the port you want to enable from the
Port Connectivity View dialog box and select Disable/Enable Port > Enable.
Disabling a port
To disable a port from the port connectivity view, right-click the port you want to disable from the
Port Connectivity View dialog box and select Disable/Enable Port > Disable.
Switch IDID Whether the switch’s insistent domain ID (IDID) is enabled. If it
is enabled, the IDID is the same ID that is requested during
switch reboots, power cycles, CP failovers, firmware downloads,
and fabric reconfiguration.
Switch in Order Delivery Whether switch in-order delivery is enabled.
Switch IP The switch’s IP address.
Switch Port Count The number of ports on the switch.
Switch Role The role of the switch; for example, subordinate.
Switch Routing Policy Whether a routing policy, for example, port-based routing policy,
is enabled.
Switch Secure Mode Whether switch secure mode is enabled.
Switch Status The operational status. There are four possible operation
status values:
• Up - Operation is normal.
• Down - The port is down or the route to the remote
destination is disabled.
• Disabled - The connection has been manually disabled.
• Backup Active - The backup TCP port is active due to a
failover.
Switch Supplier Serial Number The serial number of the switch supplier.
Switch Version The switch’s version number.
Tag The tag number of the port.
Unit Type The switch unit type.
User Port Number The port number of the user’s device.
Vendor The hardware vendor’s name.
TABLE 18 Port connectivity properties (Continued)
Field Description