Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 325
53-1002167-01
Backup support
13
6. Enter the time (using a 24-hour clock) you want the backup process to begin in the Next
Backup Start Time Hours and Minutes fields.
7. Select an interval from the Backup Interval drop-down list to set how often backup occurs.
8. Browse to the hard drive and directory to which you want to back up your data.
9. Click Apply or OK.
The application verifies that the backup device exists and that the server can write to it.
If the device does not exist or is not writable, an error message displays that states you have
entered an invalid device. Click OK to go back to the Options dialog box and fix the error.
Backup occurs, if needed, at the interval you specified.
Enabling backup
Backup is enabled by default. However, if it has been disabled, complete the following steps to
enable the function.
1. Click the SAN tab.
2. Select Server > Options.
The Options dialog box displays.
3. Select Server Backup in the Category list.
4. Select the Enable Backup check box.
5. Click Apply or OK.
Disabling backup
Backup is enabled by default. If you want to stop the backup process, you need to disable backup.
To disable the backup function, complete the following steps.
1. Click the SAN tab.
2. Select Server > Options.
The Options dialog box displays.
3. Select Server Backup in the Category list.
4. Clear the Enable Backup check box.
5. Click Apply or OK.