Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

340 Brocade Network Advisor SAN User Manual

53-1002167-01

Switch policies

Creating a DCB map to carry the LAN and SAN traffic

To create a DCB map to carry the LAN and SAN traffic, complete the following steps. This procedure

is applicable for FOS versions lower than FOS 7.0. For FOS versions 7.0 and higher, you can only

edit the the default DCB map.

1. Select Configure > DCB.

The DCB Configuration dialog box displays.

2. Select the switch to edit in the DCB Ports and LAGs table and click Edit.

The Edit Switch dialog box displays.

3. Click the QOS tab.

The Edit Switch - QoS tab dialog box displays

FIGURE 118 Edit Switch dialog box - QOS tab

4. Use “Creating a DCB map” on page 353 to create a new DCB Map or edit an existing map to

carry the traffic types, as shown in the dialog box above. Creating a new DCB map is applicable

to Fabric OS versions 7.0 and higher.

5. Click Close on the DCB Configuration dialog box.