Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 349
53-1002167-01
Switch policies
14
Editing a LAG
Use the following procedure to change members and policies in a link aggregation group (LAG).
1. Select Configure > DCB from the menu bar.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select the link aggregation group (LAG) from the Products/Ports table.
3. Click Edit.
The Edit LAG dialog box displays.
FIGURE 123 Edit LAG dialog box
4. Configure the following LAG parameters, as required:
NOTE
Ports with 802.1x authentication or ports that are L2/L3 mode enabled are not supported in a
LAG.
• Status - Enabled or Disabled. You must enable the LAG to use the DCB functionality.
• LAG ID - The LAG identifier, which is not an editable field.
• Interface Mode - L2 or none. For external ports, the L3 interface mode displays, in addition
to None or L2. If you select L3 as the interface mode, the IP/Netmask field is enabled and
you can then assign the primary and secondary IP addresses.
• A port must be in non-L2 Mode if you are adding the port as a member of a LAG.
• You cannot change the Interface Mode from L2 to none if the LAG is assigned to a
VLAN.