Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

356 Brocade Network Advisor SAN User Manual
53-1002167-01
QoS configuration
14
Assigning a DCB map to a port or link aggregation group
A port can have either a DCB map or a Traffic Class map assigned to it, but it cannot have both.
1. Select Configure > DCB from the menu bar.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a port or LAG, and click Edit.
3. Click the QoS tab on the Edit Port dialog box.
The QoS dialog box displays.
FIGURE 125 QoS, Assign a DCB Map to a port dialog box
4. Click the Assign a map check box.
If you do not enable this check box, all QoS edit features are disabled.
5. Select DCB Map in the Map Type list.
6. Select a DCB Map in the Available DCB Maps list.
If no DCB maps were created on the switch, the Available DCB Maps list is empty.
7. When you have finished the configuration, click OK to launch the Deploy to Ports/LAGs dialog
box, shown in Figure 134.