Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 361
53-1002167-01
FCoE provisioning
14
Enabling or disabling the FCoE map on the port
You must first manually disable an FCoE map-enabled port if you want to edit the VLAN ID of the
FCoE map. See “Changing the VLAN ID on the default FCoE map” on page 360 for information on
editing the VLAN ID using the Edit Switch dialog box, FCoE tab.
1. Select Configure > DCB from the menu bar.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a port and click Edit.
3. Click the FCoE tab on the Edit Port dialog box.
The Edit Port dialog box, FCoE tab displays, as shown in Figure 128.
FIGURE 128 Edit Port dialog box - FCoE tab
4. If enabled, click the Enable FCoE check box to disable the port’s membership on the FCoE
map.
5. When you have finished the configuration, click OK to launch the Deploy to Ports dialog box.
6. Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box launches.
7. Cl ic k Start on the Deployment Status dialog box to save the changes to the selected devices.