Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)
364 Brocade Network Advisor SAN User Manual
53-1002167-01
VLAN classifier configuration
14
9. Click OK to add the rule to the Available Rules list on the VLAN Classifiers dialog box and close
the Add Rules dialog box.
NOTE
Clicking Apply also adds the rule to the Available Rules list on the VLAN Classifiers dialog box,
and in addition, the Add Rules dialog box remains open and clears all entries for you to define
the next rule.
10. When you have finished the configuration, click OK to launch the Deploy to Products dialog
box, shown in Figure 134.
Editing a VLAN classifier rule
1. From the VLAN Classifiers dialog box, select a row in the Available Rules table and click Edit.
The Edit Rule dialog box displays with the fields pre-populated with the rule details. The Rule ID
field is disabled.
2. Edit the rule type and protocol type as required. If Ethernet is selected as the rule type, enter
any valid four-digit hexadecimal value within the allowed range of 0x0000 through 0xFFFF. For
the other Proto options, the hex ID value is hard-coded as follows:
• ARP—0x0808
• IP—0x8881
• IPv6—0x86DD
3. Select an encapsulation type from the list. Options include Ethv2, nosnapllc, and snapllc.
Encap only accepts a value when Protocol is selected as the rule type.
4. Click OK to add the edited rule to the Available Rules list on the VLAN Classifiers dialog box and
close the Edit Rules dialog box.
5. When you have finished the configuration, click OK to launch the Deploy to Products dialog
box, shown in Figure 134.
Deleting a VLAN classifier rule
1. From the VLAN Classifiers dialog box, select a row in the Available Rules table and click Delete.
A message displays if the rules are participating in VLAN classifier groups that are currently
associated with VLAN port or LAG members.
2. Click Yes to remove the selected rule row from the table.
3. When you have finished the configuration, click OK to launch the Deploy to Products dialog
box, shown in Figure 134.