Manualshelf

Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

ManualsBrandsHP ManualsSoftwareHP B-series Data Center Fabric Manager Enterprise Software
411412413414415416417418419420
Brocade Network Advisor SAN User Manual 369
53-1002167-01
LLDP-DCBX configuration
14
7. Click the right arrow to update the LLDP Profile parameters.
8. When you have finished the configuration, click OK to launch the Deploy to Products dialog
box, shown in Figure 134.
Deleting an LLDP profile
1. Select Configure > DCB from the menu bar.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a switch, and click Edit.
3. Click the LLDP-DCBX tab on the Edit Switch dialog box.
4. Select an existing LLDP Profile from the LLDP Profiles table in the upper right pane.
NOTE
You cannot delete <Global Configurations>. You can, however, edit global configurations. For
more information, see “” on page 368.
5. Click the left arrow button.
The selected LLDP profile is removed from the table.
6. When you have finished the configuration, click OK to launch the Deploy to Products dialog
box.
7. Cl ic k OK.
The Deployment Status dialog box launches.
8. Click Start on the Deployment Status dialog box to save the changes to the selected devices.
9. Click Close to close the Deployment Status dialog box.
Assigning an LLDP profile to a port or ports in a LAG
You create LLDP profiles using the Edit Switch dialog box, which you access from the DCB
Configuration dialog box. Global configuration parameters, which is the default selection, are
displayed in the Assigned Profile table shown in Figure 132.
NOTE
A yellow banner displayed on the LLDP-DCBX dialog box indicates that LLDP-DCBX is disabled on the
switch. The configuration options become functional when LLDP-DCBX is enabled on the switch.
1. Select Configure > DCB from the menu bar.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a port or link aggregation group (LAG), and click Edit.
3. Click the LLDP-DCBX tab on the Edit Port/Edit LAG dialog box.
The Assign an LLDP profile dialog box displays.