Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

388 Brocade Network Advisor SAN User Manual
53-1002167-01
Layer 2 access control list management
15
Fabric OS L2 ACL configuration
This section provides procedures for configuring a standard for extended L2 ACL on a device,
assigning the L2 ACL to an interface, as well as clearing L2 ACL assignments from a device.
Creating a standard L2 ACL configuration
To create a standard L2 ACL configuration, complete the following steps.
1. Select the device and select Configure > Security > L2 ACL > Product.
The Device_Name - L2 ACL Configuration dialog box displays.
2. Select New from the Add list.
The Device_Name - L2 ACL Configuration dialog box displays.
FIGURE 143 Device_Name - L2 ACL Configuration (Standard) dialog box
3. Select Standard from the Type list.
4. Enter a name for the ACL in the Name field.
5. Enter a sequence number for the ACL in the Sequence field.
6. Select Permit or Deny from the Action list.
7. In t h e Source list, select one of the following options:
• Any
• MAC
Selecting MAC enables the Source field. Enter the source MAC address on which the
configuration filters traffic in the Source field.
8. Select the Count check box to enable counting.
Count specifies the number of packets filtered (allowed or denied) for the ACL rule.
9. Click the right arrow button.
The new ACL entry displays in the ACL Entries table. To create additional ACL entries, repeat
step 3 through step 9.
10. Click OK on the Add - L2 ACL Configuration dialog box.