Manualshelf

Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

ManualsBrandsHP ManualsSoftwareHP B-series Data Center Fabric Manager Enterprise Software
431432433434435436437438439440
390 Brocade Network Advisor SAN User Manual
53-1002167-01
Layer 2 access control list management
15
d. Select the Count check box to enable counting.
Count specifies the number of packets filtered (allowed or denied) for the ACL rule.
e. Click the right arrow button.
The new ACL entry displays in the ACL Entries table. To add additional ACL entries, repeat
step 5.
6. Click OK on the Add - L2 ACL Configuration dialog box.
The updated ACL configuration displays in the ACLs table. To edit additional ACLs, repeat
step 2 through step 5.
7. Cl ic k OK on the Device_Name - L2 ACL Configuration dialog box.
The Deploy to Products - L2 ACL dialog box displays. To save the configuration, refer to “Saving
a security configuration deployment” on page 402
Copying a standard L2 ACL configuration
To copy a standard L2 ACL configuration on a Fabric OS device, complete the following steps.
1. Select the device and select Configure > Security > L2 ACL > Product.
The Device_Name - L2 ACL Configuration dialog box displays.
2. Select the ACL you want to duplicate in the ACLs table and click Duplicate.
The Duplicate - L2 ACL Configuration dialog box displays with the default name ‘Copy of
Original_Name’.
3. Enter a new name for the ACL in the Name field.
4. To edit an existing ACL rule, complete the following steps.
a. Select the rule you want to edit in the ACL Entries table and click the left arrow button.
b. Change the sequence number for the ACL in the Sequence field.
c. Select Permit or Deny from the Action list.
d. In the Source list, select one of the following options:
• Any
• MAC
Selecting MAC enables the Source field. Enter the source MAC address on which the
configuration filters traffic in the Source field.
e. Select the Count check box to enable counting.
Count specifies the number of packets filtered (allowed or denied) for the ACL rule.
f. Click the right arrow button.
The updated ACL entry displays in the ACL Entries table. To edit additional ACL entries,
repeat step 4.
5. To delete an existing ACL rule, select the rule you want to edit in the ACL Entries table and click
the left arrow button.
6. To add a new ACL rule, complete the following steps.