Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 391
53-1002167-01
Layer 2 access control list management
15
a. Enter the sequence number for the ACL in the Sequence field.
b. Select Permit or Deny from the Action list.
c. In the Source list, select one of the following options:
• Any
• MAC
Selecting MAC enables the Source field. Enter the source MAC address on which the
configuration filters traffic in the Source field.
d. Select the Count check box to enable counting.
Count specifies the number of packets filtered (allowed or denied) for the ACL rule.
e. Click the right arrow button.
The new ACL entry displays in the ACL Entries table. To add additional ACL entries, repeat
step 6.
7. Cl ic k OK on the Duplicate - L2 ACL Configuration dialog box.
The new ACL configuration displays in the ACLs table. To copy additional ACLs, repeat step 2
through step 10.
8. Click OK on the Device_Name - L2 ACL Configuration dialog box.
The Deploy to Products - L2 ACL dialog box displays. To save the configuration, refer to “Saving
a security configuration deployment” on page 402
Creating an extended L2 ACL configuration
To create an extended L2 ACL configuration on a Fabric OS device, complete the following steps.
1. Select the device and select Configure > Security > L2 ACL > Product.
The Device_Name - L2 ACL Configuration dialog box displays.
2. Select New from the Add list.
The Device_Name - L2 ACL Configuration dialog box displays.
3. Select Extended from the Type list.
FIGURE 144 Device_Name - L2 ACL Configuration (Extended) dialog box