Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 397
53-1002167-01
Layer 2 access control list management
15
7. Cl ic k OK on the Duplicate - L2 ACL Configuration dialog box.
The new ACL displays in the ACL Entries table. To copy additional ACLs, repeat step 2 through
step 7.
8. Click OK on the Device_Name - L2 ACL Configuration dialog box.
The Deploy to Products - L2 ACL dialog box displays. To save the configuration, refer to “Saving
a security configuration deployment” on page 402
Assigning a L2 ACL configuration to an interface
To assign L2 ACL configuration to a interface, complete the following steps.
1. Select Configure > Security > L2 ACL > Port.
The Port Selection - L2 ACL dialog box displays.
2. Select a port or Link Aggregation Group (LAG) in the Available Ports table and click the right
arrow button.
LAGs display in the Available Ports table using the following convention: Po LAG_Number.
3. Click OK.
The Device_Name - Port_Number/LAG LAG_Number- Layer 2 ACL Configuration dialog box
displays.
FIGURE 145 Device_Name - Port_Number - Layer 2 ACL Configuration dialog box
4. Select the Assign ACL option and choose one of the following options from the first Assign ACL
list:
• Select ACLs on this Product to assign ACLs deployed on the product to the port.
The second list is populated with the ACLs deployed on the switch or associated with a
save deployment object.
• Select ACLs bound to this interface to assign ACLs bound to the interface to the port.
The second list is populated with the ACLs bound to the interface.
5. Select the ACL you want to assign to the port from the second Assign ACL list.
6. Select the Write to device check box to configurecreate the selected ACL on the device if it
does not already exist.
7. Cl ic k OK on the Device_Name - Port_Number - Layer 2 ACL Configuration dialog box.
The Deploy to Ports - L2 ACL dialog box displays. To deploy the configuration, refer to “Security
configuration deployment” on page 400.