Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

432 Brocade Network Advisor SAN User Manual
53-1002167-01
Smart card usage
18
1. Select Configure > Encryption from the menu task bar.
The Encryption Center dialog box displays (Figure 153).
2. Select an encryption group from the Encryption Center Devices table, then select Group >
Security from the menu task bar, or right-click an encryption group and select Security.
The Encryption Group Properties dialog box displays with the Security tab selected
(Figure 154).
FIGURE 154 Encryption Group Properties dialog box - registering authentication cards
3. Locate the Authentication Card Quorum Size and select the quorum size from the list.
The quorum size is the minimum number of cards necessary to enable the card holders to
perform the security sensitive operations listed above. The maximum quorum size is five cards.
The actual number of authentication cards registered is always more than the quorum size, so
if you set the quorum size to five, for example, you will need to register at least six cards in the
subsequent steps.
NOTE
Ignore the System Cards setting. Refer to “Tracking smart cards” on page 437 for information
on its usage.
4. Click Register from Card Reader to register a new card.
The Add Authentication Card dialog box displays (Figure 155).