Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

454 Brocade Network Advisor SAN User Manual
53-1002167-01
Steps for connecting to an SKM appliance
18
3. Select Local Users & Groups under Users and Groups.
The User & Group Configuration page displays.
4. Select Add under Local Users.
5. Create a Brocade user name and password.
6. Select the User Administration Permission and Change Password Permission check boxes.
7. Sel ec t Save to save this user data.
8. Select Add under Local Groups.
9. Add a Brocade group under Group.
10. Select Save.
11. Select the new Brocade group name, then select Properties.
Local Group Properties and a User List are displayed.
12. In the User List section, select or type the Brocade user name under Username.
13. Select Save.
The Brocade user name and password are now configured on SKM.
NOTE
Fabric OS 6.2.0 uses brcduser1 as a standard user name when creating a Brocade group on SKM.
If you downgrade to version 6.2.0, the user name is overwritten to brcduser1, and the Brocade group
user name must be changed to brcduser1.
Registering the SKM Brocade group user name and password
The Brocade group user name and password you created when configuring a Brocade group on
SKM must also be registered on each Brocade encryption node.
NOTE
This operation can be performed only after the switch is added to the encryption group.
1. Select Configure > Encryption from the menu task bar.
The Encryption Center dialog box displays
2. Select the switch from the Encryption Center Devices table, then select Switch > Key Vault
Credentials from the menu task bar, or right-click the switch and select Key Vault Credentials.
The Key Vault Credentials dialog box displays (Figure 166).