Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

492 Brocade Network Advisor SAN User Manual
53-1002167-01
Creating a new encryption group
18
All configuration items have green check marks if the configuration is successful. A red stop
sign indicates a failed step. A message displays below the table, indicating the encryption
switch was added to the group you named, and the public key certificate is stored in the
location you specified.
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration. See “Understanding configuration status
results” on page 503 for more information.
15. Review important messages, then click Next.
The Next Steps dialog box displays (Figure 199). Instructions for installing public key
certificates for the encryption switch are displayed.
FIGURE 199 Next Steps dialog box
16. Review post-configuration instructions, which you can copy to a clipboard or print for later.
17. Click Finish to exit the Configure Switch Encryption wizard.
18. Review “Understanding configuration status results” on page 503.
Configuring key vault settings for Thales Key Manager (TEMS)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to “Creating a new encryption group”
on page 474.
Figure 200 shows the key vault selection dialog box for TEMS.