Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

520 Brocade Network Advisor SAN User Manual

53-1002167-01

Configuring hosts for encryption targets

Use the Encryption Target Hosts dialog box to edit (add or remove) hosts for an encrypted target.

NOTE

Hosts are normally selected as part of the Configure Switch Encryption wizard, but you can also edit

hosts later using the Encryption Target Hosts dialog box.

1. Select Configure > Encryption from the menu task bar.

The Encryption Center dialog box displays (Figure 153).

2. Select a group, switch, or engine from the Encryption Center Devices table that contains the

storage device to be configured, then select Group/Switch/Engine > Targets from the menu

task bar, or right-click a group, switch, or engine and select Targets.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then

click the Targets icon.

The Encryption Targets dialog box displays (Figure 231).

FIGURE 231 Encryption Targets dialog box

3. Select a target storage device from the list, then click Hosts.

The Encryption Target Hosts dialog box displays (Figure 232). The dialog box lists configured

hosts in a fabric.