Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

558 Brocade Network Advisor SAN User Manual
53-1002167-01
Re-keying all disk LUNs manually
18
FIGURE 263 Warning message - Re-key all
4. Click Yes.
Re-keying operations begin on up to 10 LUNs. If more than 10 LUNs are configured on the
switch, the remaining re-key operations are held in the pending state.
5. Open the Encryption Target Disk LUNs dialog box to see LUNs being re-keyed and LUNs
pending.
a. Select Configure > Encryption from the menu task bar.
The Encryption Center dialog box displays (Figure 153).
b. Select the encryption switch from the Encryption Center Devices table, then select Targets
from the menu task bar, or right-click the switch and select Targets.
The Encryption Targets dialog box displays (Figure 231).
6. Select a disk LUN device from the table, then click LUNs.
The Encryption Targets Disk LUNs dialog box displays (Figure 264).The dialog box lists the
status of the re-key operation.
.
FIGURE 264 Pending manual re-key operations