Manualshelf

Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

ManualsBrandsHP ManualsSoftwareHP B-series Data Center Fabric Manager Enterprise Software
621622623624625626627628629630
Brocade Network Advisor SAN User Manual 585
53-1002167-01
Zoning configuration
19
7. For offline zone databases only, complete the following steps to save the zone configuration
into the switch from the offline zone database:
a. Select Save to Switch from the Zone DB Operation list.
b. Click Yes on the confirmation message.
The selected zone database is saved to the fabric without enabling a specific zone
configuration.
8. Click OK or Apply to save your changes.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas.
If the zone is empty, a warning message displays.
Viewing zone properties
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Right-click the zone you want to review in the Zones list and select Properties.
The Zone Properties dialog box displays.
5. Review the zone properties.
Depending on what type of zone you selected, the following information is included in the zone
properties:
• Zone Name—The name of the zone.
• Zone Configurations Containing This Zone—The number of zone configurations to which
this zone belongs.
• Total Zone Members—The number of zone members in the selected zone.
• Number of Aliases—The number of aliases in this zone.
• Zone Members Contained by Aliases—The number of zone members in the selected alias.
• Configure Status (TI Zone and Fabric OS only)—Whether or not the TI zone is enabled.
• Configure Failover (TI Zone and Fabric OS only)—Whether or not the TI zone failover is
enabled.
• Status (not applicable for TI zones)—The status of the selected zone.
6. Click OK to close the Zone Properties dialog box.