Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 593
53-1002167-01
Zoning configuration
19
7. Add zones to the zone configuration.
For step-by-step instructions, refer to “Adding zones to a zone configuration” on page 593.
8. Click OK or Apply to save your changes.
A message displays informing you that any zones or zone configurations you have changed will
be saved in the zone database, and warning you to make sure no other user is making changes
to the same areas.
Viewing zone configuration properties
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Potential Members list.
This identifies the target entity for all subsequent zoning actions and displays the zoning library
for the selected entity.
4. Right-click the zone configuration you want to review in the Zone Configurations list and select
Properties.
The Zone Configuration Properties dialog box displays.
5. Review the zone configuration properties.
The following information is included in the zone properties:
• Zone Configuration Name—The name of the selected zone configuration.
• Number of Zones—The number of zones in the selected zone configuration.
• Total Zone Members—The total number of zone members in the selected zone
configuration.
• Number of Unique Zone Members—The total number of zone members that are unique in
the zone configuration.
• Status—The status of the selected zone configuration (active or not active).
6. Click OK to close the Zone Configuration Properties dialog box.
Adding zones to a zone configuration
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Select one or more zone configurations to which you want to add zones in the Zone
Configurations list. (Press SHIFT or CTRL and click each zone configuration name to select
more than one zone configuration.)