Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 623
53-1002167-01
Zoning administration
19
5. Click Find < between the Zones list and the Zone Configurations list.
• If the zone is found, it is highlighted in the Zones list.
• If the zone is not found, a message displays informing you of this. Click OK to close the
message box.
Listing zone members
Use this procedure to identify the zone in the active zone configuration of the fabric to which an
individual port belongs and the members of that zone.
If the seed switch is running Fabric OS 6.3.0 or later, the List Zone Members dialog box also
displays any active TI zones to which the port belongs.
Note that the procedure is performed from the main view of the Management application.
1. On the product device list of the Management application, expand the list of products to show
the ports.
2. Select a port and select Configure > Zoning > List Zone Members.
The List Zone Members dialog box displays. If the port is a member of a zone, the fabric name,
the port name, and WWN zone members display.
3. Click Close to exit the List Zone Members dialog box.
Listing un-zoned members
Use this procedure to identify the device ports in the current fabric that are not part of the active
zone configuration.
You can use this procedure for standard zones as well as LSAN zones.
1. Select Configure > Zoning > Fabric.
The Zoning dialog box displays.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select an FC fabric from the Zoning Scope list.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
4. Right-click within the Potential Members list panel and select List Un-Zone Members.
The Un-Zone Members dialog box displays. The dialog box shows the fabric name and the
connected device ports that are not part of the active zone configuration.
5. Click Close to exit the Un-Zone Members dialog box.