Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor IP User Manual 689
53-1002168-01
Adding thresholds
22
8. Click OK to add the Link Resets threshold to the table and close the Add Link Reset Threshold
dialog box.
To assign this threshold to fabrics, switches, or switch ports, refer to “Assigning thresholds” on
page 693.
9. Click OK on the Port Fencing dialog box.
Adding a Protocol Error threshold
To add a Protocol Error threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
The Port Fencing dialog box displays.
2. Select Protocol Error from the Violation Type list.
3. Click Add.
The Add Protocol Error Threshold dialog box displays.
FIGURE 313 Add Protocol Error Threshold dialog box
4. Enter a name for the threshold in the Name field.
5. (M-EOS devices only) Select the M-EOS check box.
a. Select the number of protocol errors allowed for the threshold from the Threshold errors
list.
b. Select the time period for the threshold (in minutes) from the errors per list.
6. (Fabric OS devices only) Select the Fabric OS check box.
a. Select one of the following options:
• Default—Uses device defaults. Go to step 7.
• Custom—Uses your selections. Continue with step b.
b. Enter the number of protocol errors allowed for the threshold from the Threshold errors
field.