Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

690 Brocade Network Advisor IP User Manual
53-1002168-01
Adding thresholds
22
c. Select the time period for the threshold from the errors per list. The following choices are
available:
• None—the port is blocked as soon as the specified number of protocol errors allowed
is met.
• Second—the port is blocked as soon as the specified number of protocol errors
allowed is reached within a second.
• Minute—the port is blocked as soon as the specified number of protocol errors allowed
is reached within a minute.
• Hour—the port is blocked as soon as the specified number of protocol errors allowed is
reached within a hour.
• Day—the port is blocked as soon as the specified number of protocol errors allowed is
reached within a day.
7. Cl ic k OK to add the protocol errors threshold to the table and close the Add Protocol Error
Threshold dialog box.
To assign this threshold to fabrics, switches, or switch ports, refer to “Assigning thresholds” on
page 693.
8. Click OK on the Port Fencing dialog box.
Adding a State Change threshold
NOTE
This threshold is only available for Fabric OS devices running 6.3 or later.
To add an State Change threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
The Port Fencing dialog box displays (Figure 307).
FIGURE 314 Port Fencing dialog box