Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor IP User Manual 707
53-1002168-01
Configuring an Allow/Prohibit Matrix manually
23
FIGURE 327 Active Configuration
4. Prohibit a connection between two ports by clicking the intersection point between the ports.
A prohibit icon ( ) displays at the intersection point. If you know the port addresses of the
ports for which you want to prohibit or allow communication and do not want to search the
matrix for the exact port intersection point, use the procedure “Configuring an Allow/Prohibit
Matrix manually” on page 707.
5. Repeat step 4 as needed to create the matrix you want to apply. If you want to change a
selection from prohibit to allow, click the intersection point to clear the prohibit icon.
6. When you have completed the matrix, click Save if you started with a new matrix, or Save As to
save a copy of an existing matrix.
7. Cl ic k Analyze Zone Conflicts.
This operation can be done before or after a configuration is saved. This operation checks the
current zoning settings for conflicts with settings in the Allow/Prohibit matrix. Zone conflict is
analyzed against the switch for port zoning only. The table cells display in the red background if
the two ports are not in the same zone in an active zone configuration.
8. Click Close on the Configure Allow/Prohibit Matrix dialog box.
Configuring an Allow/Prohibit Matrix manually
NOTE
If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of
possible causes.
To configure to allow or prohibit communication between specific ports manually, complete the
following steps.
1. Select Configure > Allow/Prohibit Matrix.
The Configure Allow/Prohibit Matrix dialog box displays.
2. Select a switch from Available Switches.
Two default configurations (Active and IPL) are displayed in a tree structure below the switch.
Existing configurations are also displayed.