Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor IP User Manual 711
53-1002168-01
Activating an Allow/Prohibit Matrix configuration
23
FIGURE 330 Save As/Duplicate dialog box
4. Enter a name for the configuration.
5. Enter a description for the configuration.
6. Select the check box for the device to which you want to save the configuration in the Select
Switch table.
7. Cl ic k OK.
A message displays stating that the outstanding port configuration is discarded when copying
a configuration from the switch with more ports to a switch with fewer ports and vice versa.
Click OK to close the message.
The saved configuration displays in the Available Switches table under the selected switch. To
edit this configuration, refer to “Configuring an Allow/Prohibit Matrix” on page 706 or
“Configuring an Allow/Prohibit Matrix manually” on page 707.
Activating an Allow/Prohibit Matrix configuration
NOTE
If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of
possible causes.
You must have an active zone configuration before you can activate a Allow/Prohibit Matrix
configuration.
1. Select Configure > Allow/Prohibit Matrix.
The Configure Allow/Prohibit Matrix dialog box displays.
2. Select the Allow/Prohibit Matrix configuration you want to activate. You can do this by
expanding the view for the switch under Available Switches and selecting a configuration, or
you may select the matrix under Allow/Prohibit Matrix.
3. Click Activate.
A confirmation message displays.