Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor IP User Manual 713

53-1002168-01

Changing the Allow/Prohibit Matrix display

You can modify the display using the Window Arrangement list above the matrix display or the Clear

all port names option below the display.

NOTE

If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of

possible causes.

Changing window arrangement

There are three options for the Allow/Prohibit Matrix display on the Configure Allow/Prohibit Matrix

dialog box located in the Window Arrangement list above the display.

• The matrix definitions may be cascaded (this is the default view).

• The matrix definitions may be tiled horizontally.

• The matrix definitions may be tiled vertically.

Perform the following steps to change the display to the desired format.

1. Select Configure > Allow/Prohibit Matrix.

The Configure Allow/Prohibit Matrix dialog box displays.

2. Select Cascade, Tile Horizontally, or Tile Vertically from the Window Arrangement list.

Clearing port names

Select the Clear Port Names option below the matrix display to clear all port names from the

selected matrix.

Perform the following steps to change the display to the desired format.

1. Select Clear Port Names.

A warning displays asking you to confirm the operation.

2. Select Yes to clear all port names from the matrix or select No to cancel the operation.