Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

738 Brocade Network Advisor SAN User Manual
53-1002167-01
Spanning Tree Protocol Configuration
24
Deploying STP configuration on a port VLAN
The Deploy VLAN dialog box allows you to deploy an STP configuration to target products. The
Selected Targets Summary list
FIGURE 339 STP/RSTP Configuration dialog box - Deployment Properties pane
6. Select a deployment option:
• Click the Deploy now option if you want to deploy the VLAN definition.
• Click the Save only option if you want to save the VLAN definition without scheduling its
deployment.
• Click the Schedule option if you want to schedule the deployment of the VLAN definition.
7. Select a Save Configuration option:
• Click the Running option to save the configuration while the system is running.
• Click the Startup option to save the configuration when the system starts up.
• Click the Running and startup option to save the configuration both while the system is
running and when the system starts up.
8. Click the Schedules check box, which is available if you selected Schedule as a deployment
option, to select a frequency.
9. Enter a name in the Name field that will be used to identify the configured VLAN.
10. Click the Snapshots check box if you want the Management application to run and save a
report after this configuration is deployed to the device.
11. Click OK to deploy the STP configuration on the selected port VLAN.