Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 829
53-1002167-01
Adding a policy monitor
29
6. Choose one of the following options:
• To use the default frequency (one time, runs at current system time plus fifteen minutes),
go to step 7.
• To configure the frequency, click the ellipsis button and choose one of the following
options to configure the frequency at which deployment runs for the policy monitor:
 To configure deployment to run only once, refer to “Configuring a one-time policy
monitor schedule” on page 839.
 To configure hourly deployment, refer to “Configuring an hourly policy monitor
schedule” on page 840.
 To configure daily deployment, refer to “Configuring a daily policy monitor schedule”
on page 840.
 To configure weekly deployment, refer to “Configuring a weekly policy monitor
schedule” on page 840.
 To configure monthly deployment, refer to “Configuring a monthly policy monitor
schedule” on page 841.
7. To s e t p oli c y m onitor s for fabrics, select the Fabric Checks tab and complete the following
steps.
a. Select the Check zoning status check box to determine if zoning is enabled or disabled on
the fabric.
• Select the Enabled option to determine if zoning is enabled.
• Select the Disabled option to determine if zoning is disabled.
b. Select the Check that all zones belong to at least one zone config check box to determine
if there are orphaned zones in the fabric zone database.
c. Select the Check the number of initiator ports zoned to each storage port check box to
determine the total number of initiator ports zoned to each storage port.
d. Enter the initiator port limit in the Initiator Port Limit field.
The default recommended is 20.
e. Select the fabrics to which you want to apply this policy in the Available Fabrics table and
click the right arrow button.
The selected fabrics display in the Selected Fabrics table.