Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

836 Brocade Network Advisor SAN User Manual
53-1002167-01
Deleting a policy monitor
29
Deleting a policy monitor
To delete an existing policy monitor, complete the following steps.
1. Select Monitor > Policy Monitor.
The Policy Monitor dialog box displays.
2. Select the policy you want to delete in the Monitors table.
3. Click Delete.
4. Click Yes on the confirmation message.
5. Click Close on the Policy Monitor dialog box.
Running a policy monitor
Before you run a policy monitor, make sure your policy monitors are valid. Valid policy monitors
must have at least one policy selected with one or more targets. Management checks do not
require a target.
To run an existing policy monitor, complete the following steps.
1. Select Monitor > Policy Monitor.
The Policy Monitor dialog box displays.
2. Select the policy you want to run in the Monitors table.
3. Click Run.
When the policy monitor check is complete, the Policy_Name - Policy Monitor Report displays
in a web browser.
FIGURE 367 Policy Monitor Report