Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 839

53-1002167-01

Policy monitor scheduling

• SAN Switch Checks—Displays the switch name and switch IP address and Status of the

policy check for the following options:

 SAN Switch - Check if the product is configured to send events to this server

 SAN Switch - Check if the product is configured to send Upload Failure Data Capture to

an FTP server

 SAN Switch - Check for at least Configured_Minimum_Value connections to

neighboring switches

• Host Check—Displays the Host name and Status of the policy check for the following

option:

 Host - Check for at least Configured_Minimum_Value connections to attached fabrics

• Management Check—Displays the Status of the policy check for the following option:

 Management - Check to see if the server backup is enabled and working

To export a report, refer to “Exporting SAN reports” on page 925.

5. Clickthe closebutton (X) on the Policy_Name - Policy Monitor Report browser window.

6. Click Close on the Policy Monitor dialog box.

Policy monitor scheduling

You can schedule a policy monitor to run automatically.

Configuring a one-time policy monitor schedule

To configure a one-time schedule, complete the following steps.

1. Select One Time from the Frequency list.

2. Select the time of day you want deployment to run from the Time (hh:mm) lists.

Where the hour value is from 0 through 12, the minute value is from 00 through 59, and the

day or night value is AM or PM.

3. Click the Date list to select a date from the calendar.

4. Click OK on the Schedule Properties dialog box.

To finish configuring the policy monitor, return to one of the following procedures:

• To add policy monitor, refer to step 7 of “Adding a policy monitor” on page 828.

• To edit policy monitor, refer to step 7 of “Editing a policy monitor” on page 833.