Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)
840 Brocade Network Advisor SAN User Manual
53-1002167-01
Policy monitor scheduling
29
Configuring an hourly policy monitor schedule
To configure an hourly schedule, complete the following steps.
1. Select Hourly from the Frequency list.
2. Select the minute past the hour you want deployment to run from the Minutes past the hour
list.
Where the minute value is from 00 through 59.
3. Click OK on the Schedule Properties dialog box.
To finish configuring the policy monitor, return to one of the following procedures:
• To add policy monitor, refer to step 7 of “Adding a policy monitor” on page 828.
• To edit policy monitor, refer to step 7 of “Editing a policy monitor” on page 833.
Configuring a daily policy monitor schedule
To configure a daily deployment schedule, complete the following steps.
1. Select Daily from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 0 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Click OK on the Schedule Properties dialog box.
To finish configuring the policy monitor, return to one of the following procedures:
• To add policy monitor, refer to step 7 of “Adding a policy monitor” on page 828.
• To edit policy monitor, refer to step 7 of “Editing a policy monitor” on page 833.
Configuring a weekly policy monitor schedule
To configure a weekly schedule, complete the following steps.
1. Select Weekly from the Frequency list.
2. Select the time of day you want deployment to run from the Time (hh:mm) lists.
Where the hour value is from 0 through 12, the minute value is from 00 through 59, and the
day or night value is AM or PM.
3. Select the day you want deployment to run from the Day of the Week list.
4. Click OK on the Schedule Properties dialog box.
To finish configuring the policy monitor, return to one of the following procedures:
• To add policy monitor, refer to step 7 of “Adding a policy monitor” on page 828.
• To edit policy monitor, refer to step 7 of “Editing a policy monitor” on page 833.