Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 851

53-1002167-01

SNMP traps

Removing a trap recipient from one or more switches

1. Select Monitor > SNMP Setup > Product Trap Recipients.

The SNMP Trap Recipients dialog box, shown in Figure 372, displays.

2. Click Remove from the Action list.

3. Enter the IP address of the SNMP trap port (the recipient server) in the Recipient IP Address

field.

4. Select the fabric or switches from the Available list.

NOTE

For IP products, only switches are available to select.

5. Click OK.

The Management application removes the recipient from the managed switches.

SNMP trap forwarding

The SNMP Trap Forwarding dialog box allows the Management application to forward received

SNMP traps to product trap recipients.

You can use the SNMP Trap Forwarding feature to set up filters to determine which traps will be

forwarded. The filters can be one of the following:

• Severity of the trap

• Available products type

• Trap type

• Message types (application messages or pseudo events)

Perform the following steps to forward SNMP traps.

Select Monitor > SNMP Setup > Trap Forwarding.

The SNMP Trap Forwarding dialog box, shown in Figure 373, displays.