Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

858 Brocade Network Advisor SAN User Manual
53-1002167-01
SNMP traps
30
FIGURE 377 SNMP v3 Credentials dialog box
4. Type the user name in the User Name field.
For configurations that do not have authentication or privacy, the Management application
uses the user name to match for authentication.
5. Select an authentication protocol from the Auth Protocol list. You can select -None-,
HMAC-MD5, or HMAC_SHA. HMAC_MD5 is the default.
If you select no authentication, the Management application uses the user name to match for
authentication.
6. Type a password in the Auth Password field and re-type the password in the Auth Confirm
Password field.
7. Select a privacy protocol from the Priv Protocol list. You can select -None-, CBC_DES, or
CFB_AES_128.
If you select no privacy, the Management application uses the user name to match for
authentication.
8. Type a password in the Priv Password field and re-type the password in the Confirm Priv
Password field.
9. Click OK.
Adding an SNMP v1 or v2c community string
To add an SNMP v1 or v2c community string credential, complete the following steps:
1. Select Monitor > SNMP Setup > Event Reception.
The Event Reception dialog box displays.
2. Click the Accept SNMPv1/v2c traps with only these community strings button.
3. Click Add.
The SNMP v1/v2c Community String dialog box, shown in Figure 378, displays.