Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

870 Brocade Network Advisor SAN User Manual
53-1002167-01
Event action definitions
30
• in – Matches collection
• not_in – Does not match collection
• ~ – Arbitrary Unicode regular expression
5. Enter the value of the varbind. The value you enter must conform to the data type required by
the varbind. For example, if the varbind expects an integer and you enter a text string, your
entry will be rejected. Alternatively, you can select values from dropdown choices, as shown in
Figure 386.
6. Click Next.
The Sources pane of the Add Event Action Sources dialog box displays. Proceed to “Selecting
source address products and ports” on page 870.
Selecting source address products and ports
The Sources pane of the Add Event Action dialog box, shown in Figure 387, allows you to enter the
IP address, the world wide name, or the name of the source. Alternatively, you can select source
address products to use as event senders from the available list of sources. You can select from
the available list of SAN products, IP products, or Hosts by selecting the appropriate tab.
FIGURE 387 Sources pane of the Add Event Action dialog box
Perform the following steps to configure the identity of the source.
1. Select Monitor > Event Processing > Event Actions.
The Event Actions dialog box displays.
2. Click Next to advance to the Sources pane.
3. Select the Use Ifindex in source matching check box if you want to use ifIndex to filter traps on
a specific port of a product; otherwise, the filter is applied globally on a product.
4. If the Use IfIndex in source matching check box is selected, select the varbind to be used from
the Trap Varbind (IfIndex) list.