Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

884 Brocade Network Advisor SAN User Manual
53-1002167-01
Pseudo events
30
Refer to “Creating an event action with a pseudo event on the flapping policy” on page 890 for
complete instructions.
4. Enter a description in the Message field. This description is displayed in the event log for this
pseudo event.The event log displays the exact text you enter in this field; therefore, this
message should describe the events in the event action policy.
5. Select a severity from Severity list. You must assign a severity to the pseudo event.
6. Click Next.
The Events pane of the Add Pseudo Event dialog box, shown in Figure 396, displays.
Filtering pseudo event traps
The Events pane contains a Selected Down Trap list and a Selected Up Trap list. The Selected Down
Trap list defines the traps for the down state of a product or an interface. The Selected Up Trap list
defines the traps for the up state of the product or an interface.
NOTE
By default in a SAN+IP configuration, all traps known to the Management application are included
in the Available Traps list, under the folders for the MIB to which they belong.
1. Select Monitor > Event Processing > Pseudo Events.
The Pseudo Events dialog box displays.
2. Click Add.
The Events pane of the Add Pseudo Event dialog box is shown in Figure 396.
3. Click Next to navigate to the Events pane.
FIGURE 396 Events pane of the Add Pseudo Event dialog box