Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 899
53-1002167-01
Event custom reports
30
Editing a report definition
For your definitions, you can modify the definition and save the changes you have made. For a
shared definition from another user, you can modify the definition, then run that definition to obtain
the desired report; however, you will not be able to save your changes. Complete the following steps
to edit a definition.
1. Click the Report Definitions tab and select the definition you want to modify.
2. Click Edit.
3. When the Add/Edit Report Definition dialog box displays, modify the definition. (Refer to
“Filtering a report definition” on page 895.)
4. When you have finished, perform one of the following tasks:
• If you own this definition, the OK button is available. Click OK to save your changes.
• Click Run to generate the report.
• Click Cancel to discard your changes and exit the Report Definitions tab of the Event
Custom Reports dialog box.
Deleting a report definition
You can delete a definition if it belongs to your user. Perform the following steps to delete a
definition.
1. To access the dialog box, select Reports > Event Custom Reports.
The Event Custom Reports dialog box displays.
2. Click the Report Definitions tab of the Event Custom Reports dialog box and select the
definition you want to delete.
3. Click the Delete button.
A message displays, prompting you to confirm the deletion.
4. Click Yes to delete the definition or No to cancel your request.