Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 901
53-1002167-01
Event custom report schedules
30
Adding an event report schedule
The Add Schedule dialog box, shown in Figure 404, allows you to select an existing report definition
and configure the parameters for when the report is run and to whom the report is sent.
1. Select Reports > Event Custom Reports.
The Event Custom Reports dialog box displays.
2. Click the Schedules tab.
3. Click the Add button.
The Add Schedule dialog box displays.
FIGURE 404 Add Schedule dialog box
4. Enter the name of the new schedule in the Name field. You must enter a unique name for the
schedule. The name can be up to 64 characters in length and it is case-sensitive.
5. Select the Suspend schedule check box if you want to disable the schedule. For example, you
may want to temporarily prevent a report from being generated until further notice. You can
clear the check mark to resume the automatic generation of the report.
6. Select the report definition you want to schedule from the Report Definition list. If a report is
deleted, the corresponding schedule will be deleted.
7. Select one of the following periods from the Frequency list:
• One Time
• Hourly—If you selected Hourly as the schedule type, Minutes past the hour appears. Select
the minutes after the hour when the definition report will be generated.
• Daily—If you selected Daily as the schedule type,Time (hh:mm) appears.