Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor SAN User Manual 55
53-1002167-01
SAN discovery overview
3
19. Click OK on the Add Fabric Discovery dialog box.
If the seed switch is not partitioned, continue with step 20.
If the seed switch is partitioned, the Undiscovered Seed Switches dialog box displays.
a. Select the Select check box for each undiscovered seed switch to discover their fabrics.
b. Click OK on the Undiscovered Seed Switches dialog box.
20. Click Close on the Discover Fabrics dialog box.
Reverting to a default SNMP community string
To revert to the default SNMP parameters, complete the following steps.
1. Select Discover > Fabrics.
The Discover Fabrics dialog box displays.
2. Select an IP address from the Discovered Fabrics table.
3. Click Edit.
The Add Fabric Discovery dialog box displays.
4. Select the Automatic option.
5. Click OK on the Add Fabric Discovery dialog box.
6. Click Close on the Discover Fabrics dialog box.
Removing a fabric from active discovery
If you decide you no longer want the Management application to discover and monitor a specific
fabric, you can delete it from active discovery. Deleting a fabric also deletes the fabric data on the
server (both system collected and user-defined data) except for user-assigned names for the device
port, device node, and device enclosure information.
To delete a fabric from active discovery, complete the following steps.
1. Select Discover > Fabrics.
The Discover Fabrics dialog box displays.
2. Select the fabric you want to delete from active discovery in the Discovered Fabrics table.
3. Click Delete.
4. Click OK on the confirmation message.
The deleted fabric displays in the Previously Discovered Addresses table.
5. Click Close on the Discover Fabrics dialog box.