Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

DCFM Enterprise User Manual 83
53-1001357-01
Editing a call home center
3
10. Click Send Test to test the Connect EMC application.
The selected call home center must be enabled to test the Connect EMC application.
A faked event is generated and sent to the selected call home center. You must contact the call
home center to verify that the event was received and in the correct format.
11. Click OK.
The Call Home dialog box displays with the call home center you edited highlighted in the Call
Home Centers table.
12. Click OK to close the Call Home dialog box.
Editing the HP LAN call home center
To edit an HP LAN call home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
The Call Home dialog box displays.
2. Select the HP LAN call home center you want to edit in the Call Home Centers table.
3. Click Edit Centers (beneath the Call Home Centers table).
The Configure Call Home Center dialog box displays (Figure 33).
FIGURE 33 Configure Call Home Center Dialog Box (HP LAN option)
4. Make sure the HP LAN call home center type displays in the Call Home Centers list.
5. Select Enable to enable this call home center.
6. Enter the IP address of the call home center in the Service Gateway field.