Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

84 DCFM Enterprise User Manual
53-1001357-01
Enabling a call home center
3
7. Click Send Test to test the address.
The selected call home center must be enabled to test the IP address.
A faked event is generated and sent to the selected call home center. You must contact the call
home center to verify that the event was received and in the correct format.
NOTE
The HP LAN Call Home alert displays the directory separation characters with a double
backslash (\\) instead of a single backslash (\).
8. Click OK.
The Call Home dialog box displays with the call home center you edited highlighted in the Call
Home Centers table.
9. Click OK to close the Call Home dialog box.
Enabling a call home center
To enable a call home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
The Call Home dialog box displays.
2. Select the Enable check box of the call home center you want to enable in the Call Home
Centers table.
3. Click OK to close the Call Home dialog box.
Enabling support save
NOTE
Only supported on Fabric OS switches with firmware 5.2 or later.
When you enable Support Save through the call home center, all call home events trigger the
Support Save operation and the Support Save stored location on the FTP server is transmitted with
the call home event.
To enable a support save for a call home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
The Call Home dialog box displays.
2. Select the Support Save check box of the call home center for which you want to enable
support save in the Call Home Centers table.
3. Click OK to close the Call Home dialog box.