Data Center Fabric Manager Enterprise User Manual v10.3.X (53-1001357-01, November 2009)

100 DCFM Enterprise User Manual
53-1001357-01
Restoring data to a new server
3
Restoring data to a new server
If your Management application server fails and you must recover information to a new server,
complete the following steps.
1. Restore the data (Refer to “Restoring data” on page 99 for complete instructions).
2. Configure an explicit server IP address (Refer to “Configuring an explicit server IP address” on
page 125 for complete instructions).
Display
You can configure the display for FICON and reset the display to the default settings.
Setting your FICON display
FICON display setup rearranges the columns of any table that contains end device descriptions to
move the following eight columns to be the first columns: FC Address, Serial #, Tag, Device Type,
Model, Vendor, Port Type, and WWN.
To set the FICON display, complete the following steps.
1. Select SAN > Options.
The Options dialog box displays (Figure 35).
FIGURE 35 Options Dialog Box (Display option)
2. Select Display in the Category list.